The fuel injection timing (the only engine timing on a diesel) should not be the source of vibration unless it is grossly mis-adjusted and causing misfire. More advanced injection timing will increase power, reduce smoke, but greatly increase nitric oxide emissions. It should also reduce the...
My x1100CW also short cycles a cooling fan. I have not paid too much attention, but I did find it odd. The engine coolant rarely or never goes above 3 bars on the dash readout.
VA1100, yes, similar to mine except my my shaft was still connected to the "splines." So I would say in my case the CV joint itself separated. I have only 76 hours on mine, so it was a real disappointment. The only thing different that I did this time was roll my right wheel up on a snow/ice...
I owe everyone an apology. After looking at the service manual and reviewing the problem in my mind, I made an error in describing the problem. The CV joint near the axle broke. It looks like the "CVT shaft unit" is made up of 3 shafts, with two CV joints. The outer CV joint at the wheel...
Thanks for the comments. I just purchased a service manual, and will take a look at it to see if I can better understand what might have happened. You are correct that there is a castellated nut and cotter pin, and they are still in place. They did not fall off. And you are correct that...
I dropped the RTV off at the dealer today, and hopefully it will be ready to pick up in a couple of weeks. I need to check into the warranty, but I think the time has expired on my unit. Big snow is forecast for this weekend at higher elevations, so hope I can get it back into the property...
I am not very experienced at plowing snow, having spent most of my years in south Texas. However, the Boss V-Plot seems rugged, and capable of pushing the snow wherever it is desired.
I misunderstood your question, thinking you were asking if it had been jacked up. You were probably asking if there was a lift kit installed. No, a lift kit had not been installed.
Had a disaster with my fairly new RTV x1100c. I was snow plowing and lost 4 wheel drive. The CVT shaft for the right front wheel came out of the wheel hub and was flopping around free. We tried to stuff it back in, but found a broken bearing race and some loose bearings. I am going to take...
Rat Zapper and/or rodent repellent
I have used a rat zapper (Rat Zapper Ultra Rodent Trap - No touch, No see disposal - Rat Trap RZU001-4) in my barn/garage and it electrocutes the mice and rats. Quicker and more humane than the sticky traps. Too small for a larger animal to get in. Between...