Recent content by dkf435

The Racor will work but because it will not be able to be mounted low on the frame where the Kubota one mounts, you will probably need a pump or something to prime the filter after changing or draining water as the RTV is using a mechanical fuel pump and not electric like the BXs have. The nice...

There is a kit for a water separator for the 900 and with some modifications made it work on my RTV 1100. Item # K7561-92400 http://www.colemanequip.com/parts/KubotaParts/K7561-92400/204 David

Have same kit, just wire a relay in so that when you turnremote on it energizes relay and feeds power to the accessory position on key switch, it is seperate curcuit from the run circuit.</p> </p> David</p>

It is like the one at the bottom of this page but has a plastic bowl. http://www.deenimplement.com/kubota_rtv_access.htm</p> <span style="font-size: x-small;">K7561-92400 </span></p> <span style="font-size: x-small;">The filter by itself is used on some B series and L series...

The fuel filter kit for the RTV 900 will also fit the 1100, holes already on right frame between engine and tank, only thing you need are new hoses as the ones in the kit are too short. Put it on my 1100 and just drop bowl to empty, it has a fuel shutoff buit in and cuts it off whenever bowl is...

Put the water separatorfilter kit on my RTV1100, twist bowl off and dump the waterout. If you want to change filter pry out and put in new element with O rings and screw back on. Once filter seats the fuel valve opens and air bleads to tank and it fills up with fuel. It is alot better then the...

Have same problem first thought it may of been the mounts for the lights or maybe capillary action around the lip of the roof sucking the drips back up inside. I took headliner out and found rust streaks on headliner, might be combination of the two looking for answers also.</p> </p> David</p>

<P mce_keep="true">Lift up the hood, bed and crawl underneath the two there are lots of things that are changed. Go read about problems on the 900 and I think alot were addressed on the 1100 design.</P> <P mce_keep="true">David</P>

<P mce_keep="true">The mounting kit comes from Warn. What is nice is that all the wires are pre-cut, terminated, and wrapped. Only thing that was lacking was instructions on where to mount the remote control socket.</P> <P mce_keep="true">David</P>

I think the only difference between the two is that the xt 40 is wider. You may just have to get the factory mount and drill an extra set of holes for the Xt 40.</P> </P> David</P>

The depression allows the optional rear screen to be rotated up to clean the rear glass.</P> </P> David</P>

Only thing that I can say about the rear screen and adding extensions to the bed it to check the clearance very carryful as you lift the bed up. Found out first time with load of fire wood that if you have anything near the top of bed and to the front of it that it can contact the screen in the...

Re: How many has tried this ~~~~ Yes it does work. Have the RTV1100 and it comes with a hand throttle. You can pull the throttle cable out and it has a detent to have a higher then normal idle but not full throttle, useful in sumer to keep airconditioner going. You can manually pull it out to...

Re: 1100 &gt;&gt;&gt; Removed IT &lt;&lt;&lt;&lt;&lt; Not sure if the one for the 900 has as much surface area as the one inside the 1100 muffler does and it may clog up faster with the larger engine.Pulled mine of the 1100 the other day and with 57 hours it had medium buildup, just comes out...

If you are careful and know what you are doing you can take the switch apart and flip the rocker part, but do not loose the contacts or the springs.</P> David</P> </P>