Recent content by DougK

I am thinking it might be electrical as the needle is in the same position when turned on as it is when off.</p> </p>

Has anyone had problems with the gas guage notworkingin cooler weather (60degrees or colder)? </p> When the temp drops below 60 degrees the gas guage does not function, when the temperature warms up the gauge warms up.</p> </p> Thanks</p> Doug</p> </p>

I ended up with the removable floor moun from Rugged Gear </p> </p> </p> When not mounted there is just a floorplate</p> </p> </p> I ended up getting it from Cabelas</p> </p>

Right. I have one other garage that is lower hence the removable light.</p> </p>

Ok after over a year I finally purchased a Golight. I endedup with the base unit because it was removeable and used the cigarette lighter, so I did not have to do any extra wiring. With the fog lights in the front and the rear work light I mounted the light near the back which will allow me to...

I keep a 1x1 piece of wood that is about 12 inches long and a hammer with the fuel. When putting the cap on I hand tighten until snug then tap the cap closed, the cap has little cut outs than allow the wood to fit in there perfectly. To open I just tap the cap in the other direction.</p>

I used the tire when I am getting in and out of the bed. My 20 month old daughter is lifted in and out of the bed and older children just climb in. It works well.

Kubota Technician could you share the specifics of the recall? Thanks Doug

I went with the Herculiner for apprx. $80 from Ace delivered to the local store. I have been very pleased with the performance of the do-it-yourself roll in liner. We emded up using the Herculiner in the bed and pedals. I did not use the liner on the floor boards of the cab because in my opinion...

I am looking at 10 amp lights asthe Kubota provided relay supplied with the rear work light was installed. THe Kubota has the OEM windshield and the plastic top. Hence the lights will need to be small given they willbe installedunder the plastic top on the lip that hangs over the windshield.</P>...

I just install the Kubota rear worklight and am looking to add additional lights to the front. But I am looking to use the exiting connector on the wiring harness. The rear worklight is 10 amps. Has anyone installed non OEM lights using the existing connector on the wiring harness? </P>...

</P> </P> how did the installation go?</P>

You also might want to check the bolts that connect the ROPS to the RTV. I found several of those bolts were loose.</P> </P>

As I have just found out someone from Kubota monitors this site. I would respectfully suggest that Kubota offer us free hats for being loyal Kubota RTV900 customers and for the wealth of knowledge and excellent feedback Kubota marketing and product management gleans from this forum.</P> </P>...

Is this an example of "THE MAN" keeping the people down? [:D][{][}]</P> I'm joking if Kubota requested it be removed I am sure they have good reasons. Having said that, I could use a windshield and would not be opposed to Kubota providing it for free. [:O]</P> Doug</P>