Recent content by JasonN

I replaced the front CV joint and can confirm that it just pulls out of front diff. I had to remove the upper and lower ball joint mounts to get the axle in.

This isn't Kubota but looks like I was right. You just pull it off.

Thank you. I saw that clip when I ordered the shaft. I can't see how you would remove that clip. I'm thinking that you just pull/pry the end out of the differential and the clip compresses. Surely you don't have to split the case to change the axle. There are a ton of aftermarket axles out...

I have a 2018 RTV X1100C with about 300 hours on it and the front CV joint snapped. I'm surprised it failed so quickly with the only hard use is plowing snow. I see on youtube there are some videos on the older RTV 900's that require three bolts to be removed at the front differential. The...

That’s the way mine is used. Lots of starts and stops and used a few minutes at a time. I’m just going to change all the fluids and filters regardless of what the manual says.

I’ve always heard that the HST oil and filters needs changed at 50 hours. I’m at 265 right now and pulled out my manual. It states that the filters need changed at 50 hours and then 200 but the oil is good for 400. Is this right? My Kubota L4600 operators manual says the same thing. Also...

I need a plow for my X1100C. My dealer has a SnowEx in stock. I was going to go with the Boss V-plow but the SnowEx looks good as well. Does anyone have opinions based on experience with either brand? Here is link on SnowEx https://www.snowexproducts.com/product/utv-v-plow/

I'd like to install a high intensity strobe light on my RTCX1100X. I was thinking of something like this: https://www.amazon.com/Xprite-Intensity-Enforcement-Emergency-Construction/dp/B00JSCK650/ref=pd_ybh_a_2?_encoding=UTF8&psc=1&refRID=0FYSEVG1HPTGCNMR9MEY I will be plowing this winter and...

I found the link you posted and it does not work any longer. I'm going to buy one.

Ok. I'll look for the shop manual. I did remove the HST rod and the throttle cable before I checked the pedal movement. I adjusted the stop bolt under the pedal all the way down. The throttle pedal still moved the cross shaft because that is what it is connected to and over centered. It...

I found this yesterday and applied these recommendations. My RTV is a 2018 RTVX1100C. First, the pedal did not bottom out. It rolled over the cam as it went too far with the HST speed rod disconnected. That only happened the first time and not the subsequent times. I then pushed the pedal...