Net Tractor Talk

Net Tractor Talk (
-   Kubota Tractor Forum (
-   -   Hydraulic problem (

royt 10-24-2017 10:09 AM

Hydraulic problem
Just bought a L3901 with a L525 front loader. I was dumping a load of dirt when I noticed that the quick connect on the right side came detached. I lowered and removed the bucket. after checking everything out I cannot find anything bent or broken. The problem I have now is that when I curl the quick connect plates up and start to curl them down the right side will go out about two inches before the left plate starts to move. When I curl the quick connect plates all the way down and start to curl them back up the left plate will go out about two inches before the right plate starts to move. Now there is no way to hook up an implement because the quick connect plates are out of alignment. the bucket was hang by the left plate only before lowered it to it ground. HELP

Lee1935 10-24-2017 10:36 AM

Just a little air? on my off brand tractor cycling the system soon works the air out

royt 10-24-2017 10:56 AM

Tried that a couple of times. Might go out and cycle it some more and see if it helps. Thanks for the reply

aurthuritis 12-27-2017 08:17 AM

try raising the loader arms all the way up with the bucket curled up and cylinders collapsed. then turn off the engine and with the control allow the bucket to uncurl by gravity and do the same with the lift cylinders. repeat a few times and see if that helps

Luckystars 10-12-2018 11:05 AM

Have you tried shutting down and just pushing one out or in to align them? The only resistance will be the seals in the rams. They are connected directly together. worse case nudge a tree with the one sticking out.

All times are GMT -5. The time now is 07:55 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2002 - 2018,