Search results

I got a metal handle from a tractor trailer I Think it was a MACK cab they were bolted in. I have not installed yet. you will just drill and tap into post and bolt on like probably 1/4 " bolts. its plenty strong enough to hold that's what it was in the truck a lot of times they are on the...

ANYONE KNOW OF ANYWHERE TO GET CV BOOT FOR FRONT PROPELLER SHAFT FOR 4 WHEEL DRIVE. 1100 rtv cw. MESSICKS IS 85.00 for one, sounds high to me

IS THERE ANY PLACE OTHER THAN MESSICKS TO GET THE RUBBER CV BOOTS FOR FRONT PROPELLER SHAFT 85.00 SOUNDS HIGH TO ME

Yes it is the front propeller shaft. Hope it comes out as easy as you said thanks so much

I tried to use search for this information but I guess I don't have enough skill to do it. I have a torn boot on front of the front 4 wheel drive shaft. wanted to get some info for removal before starting, it is the one piece shaft. also I have not bought a shop manual for this machine, would...

Been thinking of removing 2 of the leaf springs on each side of rear of 1100 rtv 2008 mod with full cab. will replace springs with spacers to keep same thickness. very rarely carry heavy loads, and if I did wouldn't rubber stops prevent any damage. The reason for trying this is the machine rides...

No one ever said what to do with factory fuel pump

part # on invoice is TUS-RTV1. If you pull up part number on Messicks site it crosses over at ujoint store My RTV is 1100 cw with cab has 631 hrs I only put 200 hrs on it since I had it. only inner ujoints were bad but wanted to replace everything while I had it down. I need to learn how to...

I just did my first rear u joint replacement replaced everything bearings, seals, all u joints. Bought u joints from the U joint store. (theujointstore.com) perfect fit no grinding or any problems great to deal with $ 25.00 each with grease fittings. Just thought I would let everyone know I...

uses same oil right?

Had to drain hydro oil due to rear u joint replacement, oil in transmission yellowish in color, not alarmed until I drain reservoir this fluid clear just like new. Any ideas what is going on?

Yeah thats what I thought also, but just my luck I guess. Got it back from shop Monday and installed all is well!!! cost 83.00 thanks to all inputs.

took off today took to shop the clutch for gear drive was toast due to water , armature and brush system ok no water there. They had to order part estimate is 75 to 100 yahoo thanks for the input nice to talk with others about problems and solutions.

Thanks to all for the input hope to get time to remove tomarrow

That was one of my first thoughts also especialy after finding out the cost of new one. Hate being without it, a must at my hunting club. And hunting getting good!! Thanks for response.

drove rtv 1100 into water hole at hunting club wasn't expecting it to be deep, big mistake. now starter started to sound like battery was week but battery is good, now starter just spinning not engaging. new one almost 600.00. very expensive mud hole. Any ideas on a replacement or repair. Auto...

2008 1100 hour meter stopped working. anybody know if it can be repaired it looks like it is one unit with instrment panel.

it did make a sound mabe like brakes dragging that one time mabe hopefully that's all it was I will check break linkage

Was riding over new hunting club yesterday very hot, rtv seemed to be getting sluggish was in M or L most of time when got back road put in H didnt want to pull went back to M pulled off. took break about 45 min seemed to be better. Hydro and filter changed 25 hr ago. Used Kubota oil but not...

What is the best way to adapt Farmall 100 to use 3 point appliances.