Search results

  1. B

    FRONT PROPELLER SHAFT CV BOOT

    ANYONE KNOW OF ANYWHERE TO GET CV BOOT FOR FRONT PROPELLER SHAFT FOR 4 WHEEL DRIVE. 1100 rtv cw. MESSICKS IS 85.00 for one, sounds high to me
  2. B

    2008 1100 rtv front drive shaft removal

    I tried to use search for this information but I guess I don't have enough skill to do it. I have a torn boot on front of the front 4 wheel drive shaft. wanted to get some info for removal before starting, it is the one piece shaft. also I have not bought a shop manual for this machine, would...
  3. B

    Removing part of rear springs 1100

    Been thinking of removing 2 of the leaf springs on each side of rear of 1100 rtv 2008 mod with full cab. will replace springs with spacers to keep same thickness. very rarely carry heavy loads, and if I did wouldn't rubber stops prevent any damage. The reason for trying this is the machine rides...
  4. B

    U Joint store

    I just did my first rear u joint replacement replaced everything bearings, seals, all u joints. Bought u joints from the U joint store. (theujointstore.com) perfect fit no grinding or any problems great to deal with $ 25.00 each with grease fittings. Just thought I would let everyone know I...
  5. B

    hydro oil issue

    Had to drain hydro oil due to rear u joint replacement, oil in transmission yellowish in color, not alarmed until I drain reservoir this fluid clear just like new. Any ideas what is going on?
  6. B

    Starter repair

    drove rtv 1100 into water hole at hunting club wasn't expecting it to be deep, big mistake. now starter started to sound like battery was week but battery is good, now starter just spinning not engaging. new one almost 600.00. very expensive mud hole. Any ideas on a replacement or repair. Auto...
  7. B

    Hour meter stopped working

    2008 1100 hour meter stopped working. anybody know if it can be repaired it looks like it is one unit with instrment panel.
  8. B

    08 1100 not wanting to move

    Was riding over new hunting club yesterday very hot, rtv seemed to be getting sluggish was in M or L most of time when got back road put in H didnt want to pull went back to M pulled off. took break about 45 min seemed to be better. Hydro and filter changed 25 hr ago. Used Kubota oil but not...
  9. B

    3 point hitch for Farmall 100

    What is the best way to adapt Farmall 100 to use 3 point appliances.
  10. B

    Modified rear mud guards

    I was not happy with the performance of the rear mud guards on my newly accuired 2008 RTV 1100. They hung straight down allowing the tire to sling mud under rear of bed and lights also on back of tailgate. Got to thinking (look out!) if the mud guard stood out a little further that it would be...
  11. B

    Question with hydrolic lines 1100

    Disconnected hydrolic quick connect lines today to hook up another accesory. Disconnected fine but when went to go back to dump bed would not connect ,had to loosen lines to bleed off. what caused this and what needs to be done to prevent. Thanks
  12. B

    throttle linkage on 1100

    Just wanted to make sure that adjusting the throttle cable so that it gets total throttle that inj pump will allow Is alright. I am assuming that Top RPM is set through the pump. So Can't over rev. Just bought RTV and found that by pulling out throttle lock on drivers left side that had more...
Top