Search results

Geohorn, The hand throttle was not even an option from my dealer. In fact, when I asked< they were puzzled as to why I would want that. And, I cant imagine anyone using these machines for work not benefiting from such a simple feature. When the hydrostat is put under a load, the engine RPM...

I think they ALL should have been equipped with a hand throttle like yours. WOT @ low ground speed is a necessity sometimes. Its my only gripe with the machine.

Can someone explain to me why a hand throttle for an X-series is almost $100 more than one for a non X-Series? Messicks lists X-Series hand throttle for $170 while non X is a mere $75. Is there that much of a drastic design change?

No lift at all, just turned up front ride height. No rub issues at all. No loss in power.

I used a KFI 120" Quick connect wiring connection that is hooked to solenoid/battery and routed to under driver seat compartment where i keep it rolled up. On the winch end, I went with KFI 18" Quick connect. Both ordered from Summit Racing. I think I paid $75 total for both wire/connections...

27x10x12 mud tires on an offset rim. No clearance issues or power loss here. You can adjust your front suspension to ride about 1.5" higher. Easy to do with pipe wrench. No aftermarket lifts available that I know of.

I kept mine, in case me and the wife decide to go recreation ride in the Quachita Mountains about 2 hours away. I am also running Wild Thangs, on a cheap set of Delta Steel Rims and love them.

Good looking machine! Congrats, y'all will love it.

jimso, what caps are you using with your wheels? I could not get the factory ITP caps to work with my Delta Wheels.

I'm running a 2+5 offset Delta Steel Wheel, with 27" CST Wild Thang Tires. They are probably more aggressive than what you want. They are rated for Max Load of 1090 lbs per tire. I did adjust my struts with a spanner wrench for maximum height/load, but definitely not necessary. I utilize my...

I'm running 27x10's on my x1120D. No rub at all. I dont even know of a lift for these x series.

FINALLY!

Good looking machine Carpy!!

Looks nice! Did you turn the suspension up any?

These ITP Delta Wheels ran me about $140 for the set. I keep my mud tires on them for winter and deer hunting and swap out with factory wheels and tires for drier months and trail riding.My tires are CST Wild Thangs 27x9x12. They are rated for 935 lbs max load each. I bought the set for around...

I didn't care about having pretty wheels, so these worked for me. They came in the 2+5 offset I needed to go with taller tires without rubbing when I turn. I also turned my suspension all the way up.

Ford, I had a tough time finding wheel. Finding the bolt pattern was easy because it was the same as Honda. The trouble I ran into was everything in that bolt pattern had lug channels way too small for the big lug nut/lug stud heads on our Bota's. I ended up buying some black ITP Delta Steel 12"...

1/2 x 20 lug studs. 4/110 bolt pattern.

Ohio, Im not sure how long it took Alaskan, but my 50 hr service took me approximately 2 beers!

Also, the receiver mounted to C-Channel in bed was also purchased at Harbor Freight.