I have a question concerning putting 2 small hydraulic cylinders on my weed wiper and using the hydraulics on the RTV 900 WS model to raise and lower the wiper. I would be putting one of these small 11" retracted , 14" extended, cylinders on each side of the wiper. Then I would plumb them together and run a T to the rear of the RTV and hook them into the quick disconnect there. That is where the hyd dump cylinder is connected and I would just disconnect it and quick connect the wiper cylinders there. Do ya'll see a problem with this? My Dad was a hyd specialist but I never paid much attention unfortunately. Right now, the wiper has to be adjusted manually every time the grass height changes. I must turn a bolt on each threaded shaft . It is then held in place by gravity. I need those cylinders- found at surplus center, for less than 90 a piece. Thank you for any suggestions., bordercollie