Net Tractor Talk
       

Go Back   Net Tractor Talk > Brand Specific Forums > Massey Ferguson Forum

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 01-06-2016, 06:41 PM
Davlgo2 Davlgo2 is offline
Junior Member
 
Join Date: Jan 2016
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Davlgo2 is on a distinguished road
Default MF135 PTO

my 1st post...there seems to be 3 different position on the pto lever but only 1 activates the pto? MF135 1972
I don`t find the snow blower throws the snow very far....could there have been 2 different PTO speed before and only one working now .
Just bought this (old faithfull) thanks for any help
Reply With Quote
  #2  
Old 01-07-2016, 10:07 AM
Doc's Avatar
Doc Doc is offline
Chief Bottle Washer / Admin

 
Join Date: Apr 2007
Location: Ohio USA
Posts: 5,938
Thanks: 2,151
Thanked 497 Times in 315 Posts
Doc is on a distinguished road
Default

Hi Dav ....sure sounds like you nailed it. Two PTO speeds and only the slower one must be engaging. I had an even older 8n and that was it's setup also.
Probably 540 rpm and 1000 rpm. Sounds like your snow blower needs the 1000 rpm but is only working on 540 rpm. That sure would make a shorter throw for the snow.
__________________
Scott me up Beamy!

Other Fun Forums:
Forums Forums .com +++ Net Pet Talk Forums +++ Net Cooking Talk Forums +++
Reply With Quote
  #3  
Old 08-15-2016, 12:07 AM
Broncobob Broncobob is offline
Junior Member
 
Join Date: Aug 2016
Location: Georgia
Posts: 4
Thanks: 1
Thanked 1 Time in 1 Post
Broncobob is on a distinguished road
Default

Dav, all the way forward on the PTO leaver is ground speed PTO ( unless you have a muiltpower ) which means it will only rotate while the tractor is moving. All the way back is straight drive PTO which works off the back of the Hyd. pump. These are square cut splines on the Hyd. pump shaft and the inside of the slip connector and it can be quite a chore to make it engage. It will grind gears like teenage little girl learning to drive stick. I installed a new Hyd. pump in my 35 and it's a bear to engage the PTO matter of fact I shut the engine off while pushing the PTO lever all the way back. Then start it back up and off we go. Also look on the PTO base plate and it should have 3 lines on it ground speed, neutral, and PTO. I hope this helps.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





All times are GMT -5. The time now is 10:44 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2002 - 2018, www.DotHQ.com