Heatwave
Active member
After your 900 warms up and reaches normal operating temperature, where is your temp gauge needle?
My needle stays just a 1/4" or so from the edge of the red zone. My other Kubota equipment always keeps the needle somewhere near the center of the gauge ... never anywhere near the red zone.
The dealer screwed around with this after I brought it to his attention. He replaced the temp gauge ... no change. Then he popped out the thermostat and swapped it ... no change.
The needle has never gone into the red zone and it's probably nothing to worry about ... but I sure would like it to stay further away.
Anybody else experience this with your RTV 900?
My needle stays just a 1/4" or so from the edge of the red zone. My other Kubota equipment always keeps the needle somewhere near the center of the gauge ... never anywhere near the red zone.
The dealer screwed around with this after I brought it to his attention. He replaced the temp gauge ... no change. Then he popped out the thermostat and swapped it ... no change.
The needle has never gone into the red zone and it's probably nothing to worry about ... but I sure would like it to stay further away.
Anybody else experience this with your RTV 900?