DIY transport box

quincy

Member
Well just came across this thread. Did you ever build a fel? Trying now DIY copying a neighbours as couldn't get plans, ransomes ct333 like a ford 1720, fun fun fun.
No, I never did. I'm getting by just fine with the rear scoop. It's simple with few moving parts. Best of luck with your FEL build. Share a few photos as you go. Its always fun to follow a project like that.
 

Doc

Admin
Staff member
Gold Site Supporter
Nice work. Looks very sturdy. That will last for years. GREAT job.
 

Bota Fett

Active member
Site Supporter
Just flicking thru some old threads... adding a pic to this one...

The back loader I made a couple of years ago, still working strong...

Using this improvised jib I cobbled up a while back, made for lifting & placing railway ties...

Still haven't ponied up for a FEL yet... lol

DSC_0282-2.jpg


I hope you guys and gals are keeping well?
Looks like that's great for doing Wheelies!! Oh never mind, I see the weights in front.
 

Mzee

New member
Just searching for how to make a transport box for a small Kubota. Discovered this post. Thanks lads- I like Quincey's idea of separate brackets. I have a few old sheet iron tanks that might lend themselves to being cut up. Although they may be too wide at 4 ft?
Would old plough 'scrapes' do to make a cutting edge? Or is there a cheap source of strengthened steel to do the job. I'm in Irish Midlands.
thanks to both of ye for some great ideas.
 
  • Like
Reactions: Doc
Top