Okay, got the FEL on and working. I do have to replace one hose for the bucket side but thats all.
Hey CA, followed your directions and it set up and worked perfect. As far as the joint pins, I ended up searching every tractor supply, ag supply place withing a 100 miles by phone. Nowhere could I find the cylinder pins of the right size. So, just ended up using a 3/4 x 5 inch partial threaded bolt for each joint. It works.
So the FEL is working, now I need to work on the mower. Its been sitting for 8 years as well and it is REALLY stiff in the gearbox. So guess I will tear it down and clean out any grime or rust and then re lube it. Might just repaint it as well. Might just sandblast the rest of it to get rid of any surface rust. Going to start the paint job on the tractor and FEL next week I think.
Will post a photo later with the FEL and scrapper attached. Definately looks like a working tractor now.