Finally got my block heater. Kubota part # 70000-00771. I posted part of the install pictures in this message. Will post the remainder in ( 2 ) and ( 3 ) post. I couldn't upload all in one post.
I used NAPA part # 765-1149 Sleeve Retainer , Permatex # 64000 , to help hold heater in place. Instructions recommends using Loctite, I thought Sleeve Retainer would be just as good or better. I think the pictures should be self explanatory so I won't go into detail of install. I haven't decided if I'm going hang the cord out below the side panel or come out between the side panel and hood. The heater works Great. I haven't replaced the side panel assembly yet.
Larry
Northern, In
I used NAPA part # 765-1149 Sleeve Retainer , Permatex # 64000 , to help hold heater in place. Instructions recommends using Loctite, I thought Sleeve Retainer would be just as good or better. I think the pictures should be self explanatory so I won't go into detail of install. I haven't decided if I'm going hang the cord out below the side panel or come out between the side panel and hood. The heater works Great. I haven't replaced the side panel assembly yet.
Larry
Northern, In
Attachments
-
resized_IMG_3609.jpg87.6 KB · Views: 58
-
resized_IMG_3610.jpg74.7 KB · Views: 55
-
resized_IMG_3611.jpg71.2 KB · Views: 54
-
resized_IMG_3612.jpg62.7 KB · Views: 54
-
resized_IMG_3613.jpg78.6 KB · Views: 52
-
resized_IMG_3614.jpg66.4 KB · Views: 52
-
resized_IMG_3615.jpg71.5 KB · Views: 51
-
resized_IMG_3616.jpg56 KB · Views: 52
Last edited: