Fork Extentions for Loader

bakerg

Member
Need to move some stuff around and I really need a fork lift, but if you don't have one you improvise.:wink: Found a piece of 2x3 tubing that was once used to pull drag harrows and cut it for the forks. Took a draw bar off an old JD lime spreader and used this 3" channel for the back stops for the forks. Welded the channel to the fork tubes and another piece of tubing to side over the bottom of the loader bucket. Made the back of the fork tubes moveable so once you slide the forks on the loader, the back end will roatate to stop the forks from falling offf. The forks can slide to any width you want. See to work good.:mrgreen:
 

Attachments

  • 04-10-13_1821.jpg
    04-10-13_1821.jpg
    33.6 KB · Views: 49
  • 04-10-13_1822.jpg
    04-10-13_1822.jpg
    38.4 KB · Views: 48
  • 04-10-13_1823.jpg
    04-10-13_1823.jpg
    32.1 KB · Views: 47
  • 04-10-13_1824.jpg
    04-10-13_1824.jpg
    39.1 KB · Views: 46
  • 04-10-13_1825.jpg
    04-10-13_1825.jpg
    43.5 KB · Views: 47
  • 04-10-13_1826.jpg
    04-10-13_1826.jpg
    28.8 KB · Views: 47
  • 04-10-13_1850.jpg
    04-10-13_1850.jpg
    35.6 KB · Views: 48

Doc

Admin
Staff member
Gold Site Supporter
Awesome job. Forks add so much flexibility to your front end loader, I think of them as a must for anyone with a loader.
Course I am not as talented as you, I ended up buying mine from Paynes Forks. They get the job done for me.
http://www.paynesforks.com/
 

bakerg

Member
Doc, I'm just cheap:eek:, if I can find material lying around the farm I built something but I try not to by any material.:wink:
 

bczoom

Senior Member
Staff member
Gold Site Supporter
Nice job! Now you got me thinking about the scrap steel I have laying around.
 
Top