I have a 2007 1100CW and tried to remove the tail pipe to check out the arrestor. However with 450 hours and 7 years old, the small Torx screws are ... screwed! Can I cut them off with a grinder or drill them out?
Oh, howdy all. Stoney Lake, Ontario, Canada and we also have an 2005 900 as well.
I am just trying to reinstall the rear axle housing on the 1100 after replacing the left axle and bearings and hub. The inboard u-joint was toast and the split washer under the castle nut was broken meaning that the nut was NOT 140 ft-lb but was totally loose! The wheel hub split was damaged as was the corresponding splines on the axle. Bought hub/bearings/seals at Kubota dealer and OEM axle from an internet source.
TT