jbrumberg
Member
So here I was yesterday in the middle of my raised stone flowerbed project with a rather large sized rock in the bucket when the FEL control knob came off in my hand which kind of immobilized the project . The problem area is where the knob attaches to (screws into) the adaptor plate which is made of cast aluminum and very cheap aluminum at that. I kind of "jimmy rigged" a repair using a 7/16" - 20 fine thread locking nut. I contacted www.messicks.com who immediately sent me a parts diagram via e-mail. Today I will find out the cost of replacement. I might just go out and buy some loctite for my repair . Jay
My to Messicks for their responsiveness and support.
My to Messicks for their responsiveness and support.