Rtvx1100c front halogens wattage

Walnut1

Member
I ordered a Nilight light bar for the front of my new rtv, do I need to use the power supply cable, or will the existing kubota wiring that supports the factory lights be sufficient? I can’t find the wattage of the front light option anywhere.
 

shinnery

Active member
At 19.5 amps I would use at least 10 gauge wire (maybe 8 ga.) and would consider a relay to keep that current out of my switch.
 

aurthuritis

Well-known member
Site Supporter
that is a lot of amps. is this a halogen light bar? i thought the LED systems were low amperage? am i wrong???
 

aurthuritis

Well-known member
Site Supporter
just check the watts on your new lightbar and see if it is less than oem. if it is less or near oem it should be fine to use the existing wires. pretty sure the cab is pre wired so all you need is a switch
 

Walnut1

Member
I ordered the harness that is made for the light, it has a switch and relay. I’m just not to comfortable running it under my headliner.
 

aurthuritis

Well-known member
Site Supporter
i thought the harness was already under the headliner and all you need is the lights,switch and relay?
 
Top