Hi Ya,ll . I need some opinions please . I have an Iseki landleader tractor with a 155 Koyker detachable loader on it . I have never & Probablly wont ever have the need to take the loader off .
I,ve used & abused this thing & where it Rests in the mounts torwards the rear are worn bent & sloppy as all get out . I,ve been thinking about just welding the Mounting pads solid at the rear where the pull pin is as well as the slip on points torwards the front . Its got so much play in it I can move it side to side just by hand , & welds are constantlly breaking where its mounted to the frame itself from carrying full bucket loads of Material ( Dirt, Gravel & broken concrete , across the field & back & forth .
My Question is wether it could cause any other problems or would I regret it later on . I,ve sold all my other Tractors & I,m just down to this one & use it dailly . Thanks for any input or tips You might have . I can post some pics if needed . Right now this is the only pic I can find that shows the rear of the FEL mount , This was when I darned near rolled it . Thanks . Bob
I,ve used & abused this thing & where it Rests in the mounts torwards the rear are worn bent & sloppy as all get out . I,ve been thinking about just welding the Mounting pads solid at the rear where the pull pin is as well as the slip on points torwards the front . Its got so much play in it I can move it side to side just by hand , & welds are constantlly breaking where its mounted to the frame itself from carrying full bucket loads of Material ( Dirt, Gravel & broken concrete , across the field & back & forth .
My Question is wether it could cause any other problems or would I regret it later on . I,ve sold all my other Tractors & I,m just down to this one & use it dailly . Thanks for any input or tips You might have . I can post some pics if needed . Right now this is the only pic I can find that shows the rear of the FEL mount , This was when I darned near rolled it . Thanks . Bob