While baleing my 560 diesel started to make grinding gear noise when clutching in the pto. holding foot clutch untill the tranny stopped spinning gears had no effect. did not always do it. but at least 75% of the time. It would eventually engage and run the baler.
My IT manual doesnt show any gears between the pto clutch and the output shaft. And i understand that the path is engine shaft turning, pto clutch, pto shaft out the back. no gear shifting involved.
It looks like there are drive gears concentric on the pto shaft as part of the tranny, but holdng the clutch should stop all tranny gear spin.
?????????/
My IT manual doesnt show any gears between the pto clutch and the output shaft. And i understand that the path is engine shaft turning, pto clutch, pto shaft out the back. no gear shifting involved.
It looks like there are drive gears concentric on the pto shaft as part of the tranny, but holdng the clutch should stop all tranny gear spin.
?????????/