Recent content by 02dmaxx

Blacksmith,that is a real nice looking unit!Thanks for the diagram.

Chowhound,thanks.I'm near Williamsport.

Close,It's a '60 with the "Poly"318 and three on the tree.Needs alot of body work.Parts for these trucks are few and far between!

OCH,what for pump are you using? I was thinking of using a power steering pump off a truck,wonder if that would work? I see you are using two controls,what are your thoughts on a "joy stick"?

Thanks for the pics. OCH. I took a gander at your fine machine over on the other site. Few questions: Did you bush the pivot points,if so,what did you use? Did you use an upright for your fluid tank? And,is it possible to still use the original belly mower with your loader attached? Thanks in...

K,thanks fellas.

few more.

Well,I made my own sleeve hitch to start with.Then I made wheel weights out of brake rotors,turned five rib front tires into tri-ribs and am currently fixing a walk behind tiller to the hitch.Here's a few pics.

I have a few pics. but they are of "Homemade Upgrades",if you will.And I should have phrased it better.I didn't just get the cub,had it for a couple months now,but am still learning.

Anyone here w/front end loader plans that they are willing to sell/share for garden tractors? I'v been searching high and low,and found some "plans" but they are primitive! Anyone have a good set of plans? Thanks

Thanks fellas!

Hello everyone,new here.My pride and joy is a "newly" acquired 105 Cub.