Recent content by 606timm

Good morning all. I did a quick search here but couldn't find much. I was wondering if anyone has attempted to make a mounting plate or similar to use with the Kubota RTV-X1100C front quick hitch lift and four-point K-Connect? Maybe like a set of forks to get a little lift of heavy objects off...

Dang. I was trying to see what I can qualify as. My father-in-law just got pulled over on his Polaris UTV by a DNR warden for driving on the road. We never had any issues before. Lots of four-wheelers around here and UTV's parking on the road and then getting off their trailers and going to the...

I was going to fill out the MV-14 below for Wisconsin LSV but noticed the item check box on the bottom of the image about "Low Speed Vehicle manufactured for roadway use and displays required Federal Certification Label as a low speed vehicle". With the attached Certificate of Origin for my...

Ok. I'm currently chatting with our state DNR to find out. I agree, by definition, it fits. I just want to clarify what is allowed and what is needed for LSV registration.

This may have been asked already. I have searched and didn't find much. But by definition... The final rule did not include the rated cargo load requirement proposed in the NPRM. The new definition became effective October 3, 2005 and it reads: Low-speed vehicle (LSV) means a motor vehicle...

I called my dealer today and they stopped out to take a look. It turns out it was the front power unit system 150-amp breaker that was blown. Yikes. It's just too dang cold!!!!

I have been away for a week. I had my RTV-X100C sitting outside in sub-zero temperatures the entire time. It took a bit to get started this morning. After leaving it running for a bit, I engaged the PTO without issue. However, the hydraulics for the front broom (K-Connect) were very slow due to...

I got the new LED headlights installed and finally took a night picture. They pretty much match the color/whiteness of the upper lights. They are much brighter than the factory halogens. Highly recommend this upgrade if you can.

I ended up buying these.... https://www.amazon.com/gp/product/B07P8Y493C/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 Direct fit, easy to install. I will post some night time pictures when I get a chance.

Thanks mgrick. I might have to try those out.

I don’t hear any rattling so far. It is bolted in three spots and is tight. It’s attached to the muffler area with an included bolt and spacer.

Thank you again, Hunter11.

Great. Thanks Hunter11. I'll give them a try. I also have two LED floods on the top front and two on the top back as well. I usually don't drive with the floods on though. Can you share a link to your light bar as well? Was there anything that you had to make to have it fit properly?

Same here. I use the rotary broom and snowblower in low range.

Good morning, everyone. Is anyone familiar with replacement headlights for the RTV. I have a RTV-X1100C and my headlights are not too bright. I'd like to replace them with something brighter or at least a whiter light. Thought I'd check here before I start taking mine apart. Thanks. Enjoy the day.