Recent content by 73MF20

Just a follow-up. Put a 5/16" bolt through the output shaft hole and used a prybar against a wooden block I held against the casing and it popped right out. Now just waiting for the new seal to get here. Thanks for the help.

Wow, great thread, thank you! The pictures and description exactly match mine. I was afraid to damage anything internally - now that I know the shaft and bearing should come out, I will put some more effort into pulling it. Never thought about using a drive shaft to pull with - or may even set...

Thanks, but this is not a TO-20 (I had a TO-30 for many years). It's an MF20 with a MF32 loader on it and painted bright yellow - I think it's a 1973 vintage. I understand they called it an "industrial" and is very similar to the MF135 agricultural - same Perkins 3 cylinder gas engine and a lot...

New here. I am hoping someone here can help me. I am replacing the seal and o-ring on the PTO shaft that has been leaking slowly for years. Near as I can tell by the serial numbers it is a 1973 MF20 (yellow) w/6 speed manual shuttle tranny and a 'live' PTO (either engine or ground driven) The...