I second the cigar-lighter/power-outlet suggestion. It's always hot as geohorn idicated. I, too, use it for a USB cell phone adapter/charger. Ideally a small LED light with dusk/dawn sensor could be just the ticket. It's easy to find 12v leds, not so easy to find one with the dusk-to-dawn...
I can't get to my RTV now to verify those specs since it's at the deer lease almost 200 miles from here. I appreciate the responses and suggestions and will try a couple of those when I can get back down there.
I'll second (third? fourth?) that the bolt-only wheel mounts are terrible. I just had to deal with a busted sidewall down at the deer lease and getting the replacement on was a b****. I'm gonna do as Avanti Guy suggests with the extra bolts without heads for the future. I'm home now so can...
I've had the Badlands 5000 on my '05 900 for about 6 years. Haven't had to winch the 900 out of anything (yet!), but have used it several times to raise/lower deer blinds on 12 foot towers. Works great. It's mounted on a receiver hitch-type plate so I can switch front to rear as needed. I...
Best stuff I've ever used for stopping rust is OSPHO, a type of phosphoric acid. It penetrates and stops the rust in its tracks as well as acting as a bit of a primer, too. We used it on offshore platforms in a really tough environment. It's relatively cheap and water-thin so a little goes a...
Hmmm, interesting idea. I recall reading about this very thing in a couple of marine forums that I used to frequent. Apparently it's a common practice among some larger vessels to burn used oil along with diesel. I don't have any current references that I can link to, but perhaps a Google...
The temp gauge on my '05 900 stays at or near the low end unless I pull a really heavy load or run it at full throttle for some time. I had one hunting blind that was 8 miles away. Running it full throttle down the county road for 7 miles was the only time that I've ever had the gauge climb...
I wish that I had something of value to contribute to this thread, but I am REALLY enjoying all the great brainstorming going into this! I've learned several things about the RTV hydraulics already. Thank you all for sharing your ideas and expertise. What a great forum!
Front or rear winch mounting & wiring
Here's what I did on my '05 900 for the 5000 lb. HF winch I installed:
I got the winch mount and KFI quick disconnect cables on Amazon. Since my 900 has the older 1 1/4" receivers front and rear, I bought the 2" adapter locally from Northern Tools.
I...