Recent content by Chet

Starting to wonder if axles weren't correct ones

I replaced my cv axles but have a rotational knock at times, lower ball joints seem loose. Mine is a 2007, 2 piece drive shaft. Ball joints, u joints? Suggestions..thank you. Almost like a stick is stuck somewhere at times then goes away..don't see a stick. Intermittent, again, thanks

Looking at buying 1140 that wont shift into 4x4. If its a fork issue, does transmission have to be pulled

Ok, will check clamps, can i spray carb cleaner or something around injectors, other connections, to see if idle changes. Is carb cleaner the right thing to use? Thanks again.

Died on me while idling, filled fuel, bled etc. No luck, replaced injectors got it going, added a washer on fuel return line because twist and break when removing. Got it running ok but lost some power on uphill climb. I put electric fuel pump in it last year. Got injectors off Amazon. Wrong...

Update, took a minute to get return fuel lines in after breaking while trying to move injectors. Replaced all 3 injectors and return fuel rail. Bled 1, then 2, then 3 and it cranked up and kept running. Injectors must have been dirty. Added a washer on top of return fuel lines so hopefully...

I have an electric pump, plenty of flow. Started with number 3 cracked open. Opened bleeder screw, shut number 3, ran about 5 secs, died. Same as before?

Ok, will try today. Thanks

I did that, blew one back thru gas tank. I have fuel coming out of both ends of return line while running. Does this sound like injector pump malfunction?

Will not start unless i open number 3, if i try to loosen number 2 while just barely snugging number 3 it shuts off. I get spray out of number 3 when cranking, just barely get fuel out of number 2 and 1 when trying to bleed.

Ok, will do, i think it is number 3 , if 1 is closet to water pump. I will check others to see what happens.

Havent checked to see if would work the same on another one.

The one opposite the fan.

Have a 2007 kubota rtv 900. Will only stay running if injector line is left cracked open. Close it and runs about 20secs and dies.

Saw clicking comments...axle seems loose on side opposite wheel. Bearing????