Recent content by cleatusj

I would start with 2 weights and try it. You can always add more.

Try this link Cowboy. http://www.golfcartcare.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=wEhd

Put my converted David Bradly moleboard plow on today and dug ditches to drain the park next door of ground water runoff. I sure churned a lot of mud.

MBN was my first forum, but I've been a member of several tractor forums for years now, so most of my projects show up in several locations.

My very first video is of a short ride over the dirt I've been dragging out, plus a little mud. http://www.youtube.com/watch?v=OVViq9e20Fs

Got tied up with the "to do" list.

Mark, That's one thing the AENL Wisconsin doesn't come with (charging system). The rippers are 2 1/4x1 bar with bottom cut at a angle and will weld a short 1/4" tooth sticking forward.

Guys, I dug in my scrap pile and built a 44" box blade that I can use with this Suburban and 4041 Simplicity. I just came in from drilling the rippers and painting. Here's some before rippers and paint and will post some after paint tomorrow.

Oldhand, Glad I could help and I had nothing that they would fit.

chopperfreak, I didn't find the Cub but check this out. http://www.nettractortalk.com/forums/showthread.php?t=1628

It must be us strange ones that find each other in all kinds of tractor forums. If it hasn't been altered, I haven't owned it.

It's still a long ways from where I want to get it, but here's 3 pic's. The last shows the extended floorboards with a 2" lipat the rear to keep my feet from getting into the tires and it works well.

I got around to painting the hood and rims and will post pic's after washing tractor.

Got around to welding in gaps in hood and smoothing out the outer surface for paint. Also added Chevete pulley to original to power an alternator and ford power steering pump for hydraulics.

If I take them off i use a file, 8-10 strokes each end and they are ready to go.