i have a 14hp ohv techumse had lots of blow by from breather tube i put new rings ,gaskets seals new breather in it started ran fine 15 minutes later started blowing oil out breather againe oil level is fine could my valves be out of adjustment they seem to have loosend abit any ideas guys also...
yes loader is home built will put hyd for bucket on when i swich loader
to the 442 have a line on a two cly perkins for the 442 will check it out
to see if it will fit thanks jim
case 442 build
mark yes i have thougt about a diesel one of those 2cly perkins,maybe
prob get 16 hp kolher magnum out of tractor this will replace hers pic of
loader that will be on this tractor jim
hy guys thanks for the replies well the cly are 3 in pump standerd case
9.5 gpm pump 2500 psi at 3600 rpm way to much power lifts about 4.5
feet high enough to dump in my landscape trailer i also have a manure
bucket with grapple for turning my compost pile the pipe was bent with a hyd pipe...
hy guys bin busy havent been on puter much any ways thought you guys
might be interested in the loader i built for my 222m kind of the old style
but i think should be strong enough what you think jim
capacity is way to much i have to turn down the relief valve it has way to much power for the front spindels to take i can lift back end of my 16 ft landscape trailer off the ground no problem jim
hi guys well we got hammerd last few days aprox 20 in of snow blowing
snow freezing rain thunder and lighting you name it 28hr of plowing all
25 acc cleared and ready for buss monday the old cases did there job
again some pics for you if your interested jim
Overseeder
hy guys ive been gone to quebec for christmas just got back thats why i havent replied on the metering of the seed here goes the seed box
is a old walk behind drop seeder which was powerd by ground drive took the wheels off and chain drove that to the spike arerator bellow
with the...
just joined im a landscaper from ridgeway ont canada run case and ingersoll garden tractors am always fabing up some thing up for my machines or modifiing them hope to see some new ideas here and help
sombody with theres jim ill see if i can post some pics