Recent content by Lee1935

With the Kubota I suspect you will find ground clearance a big problem. The ability to pickup speed quickly to make it through short stretches of mud or snow is something you might also find a problem. As I'm sure you know boots and a winch are must haves ☺

Most are aware of why diesel fuel additives are sold. But quite a few learn about this only after having a complete system flush https://en.wikipedia.org/wiki/Microbial_contamination_of_diesel_fuel

buy the cheapest battery you can find. if not going to use it for several months use a good trickle charger. In the winter time store in a warm place and use the trickle charger. In the winter you will find 7 to 12 batteries in my basement. My oldest battery is from Cosco (12 years) Don't use...

there aren't that many gears with access to the engine oil. Camshaft, oil pump. Ebay for the manual, chances are it will be on a CD

deep cycle batteries are not made to stand the vibration automotive batteries are. Chances are you will not have a problem☺

photo shopped

There's a dealer front wheel field modification for this tractor. Facebook Kioti forum has a tractor (6 hours) that the right front wheel assembly came off.

This is my first post after recently acquiring a Yanmar YM-240. Start-up seems difficult despite what appears to be sufficient fuel. Black smoke while cranking. I use the compression release and the weather is quite warm. I followed prescribed startup procedures from manual, full throttle then...

Instead of steel washers could you cut up the sidewall of a old tire and make rubber washers?

Fram many years ago was one of the best filters you could buy. Sadly those days are gone forever. Lab tests for the past few years only give a high score to just a few filters. Napa Gold being one

Farm stores carry adapters that go from one size spline to another

You should tell your dear there ain't no such animal as "wont fit" ☺

When I was a kid, tractors and old trucks had a hole in the pan under the clutch that had a 1/8 inch hole for water & or oil to drain out. A cotter pin was dropped in the hole to let the water & oil run out and at the same time stopped some of the dust or dirt from getting in. Maybe yank the...

Kubota has been having problems with the cheap intake hoses on some models. Seem they get soft & collapse. A trip to Napa will get you neoprene hoses that should last forever,

great exercise cutting them into lengths you can manually load. My chipper will only take brush (4 inches) I try not to drag anything through dirt or mud as I'm lazy when it comes to sharpen the blades ☺