Recent content by Titleman

Archdean x2

I will certainly put you in my prayers. Tom

18..... missed 1 and 3. Ahhhhhhhh.., sure brings back the memories.:thumb: Tom

Paul Christenson has the /a great solution to this problem. This is the same thing I use. Wife got it for me as a gift. Works great. I attach the grounding cable first thing, before I do anything else. Later--Tom

I was going to adjust the rockshaft knob this past weekend and while warming her up, I raised the RC and noticed that it was not doing it (bleeding down) anymore:biggrin: . The tempurature was chilly, enough for a jacket but, not cold cold (don't remember actual degrees). Do any of you think the...

Your last sentence says it all for me. Sure would have liked growing up with one. Oh well, it's party time now and I'm a pretty happy boy. See ya,:wave: and Happy Thanksgiving's Day to all. :tiphat: Tom

We've been kinda/sorta off and on looking for a small backhoe or excavator ourselves. The couple Dougster posted a picture of , the Takeuchi 28 hp in particularly, is something that would probably be a good fit for us. Since the subject has come up, if there was a forum here, I would check it...

Welcome...., I've seen some of your post on another forum:tiphat: and look forward to your contributions here. I'm new to this site as well and have really enjoyed it so far. :D Tom

goldchaser- sorry to hear about your misfortune:sorry: ..., but, I'm sure you'll bounce back in short order. Try and do as instructed by the pros and simi-pros.:respect: Tom

bczoom, thanks for replying; the only change of any fluids has been at the 50 hr, service interval and it only has 77.4 hrs. as of today. I'm pretty sure draft control is not on mine. I have not found a switch, knob, handle, lever, button, dial or whathaveyou on it for that purpose...

That would be my JD 3720 w/cab tractor. :tiphat: :biggrin: ,and boy, what a tool it is. Tom

Mith, thanks for trying to answer my cry for help. Yes, it lifts by itself each and every time, immediatly after it drops about 3 or 4 inches. I know that over time, some if not all, will bleed down. Also, I do not have draft or position control, that I know of. I've looked through my manual and...

Farmwithjunk, I'm certainly not" hydraulic system savvy", so I'll probably end up taking it to the dealer, unless, like bczoom said, I can adjust it out using the knob for that purpose. Yes, it does it at all RPMs. Just alittle faster the higher the RPMs. Thanks , Tom

Thanks Doc, I'll also check out "Yesterday's Tractors" site.

Good day to all.I need some help figuring out how to keep my 3PH from bleeding down when I'm using my bush hog. When I raise it completely, it very slowly bleeds back down a few inches, then recharges or lifts back up and the process starts over again. It only takes about 30 to 45 seconds for...