Recent content by Tysonshurr

no it is the plate that the bearings roll on in the picture above. It looks pitted and I am wanting to replace it if possible.

Thanks cchaffee for the info. I am wondering if the bearing plate in the cradle comes out Or are they pressed in? It is pitted and should be replaced. Also I am replacing the brass plates. They don’t look bad but if I am going into the unit I don’t want to have to go in 1-3years from now ?.

Also, what oil should I use for testing/cleaning before changing out to the UDT?

Morning, Well I took a few more things apart last night and this am to find out how bad it is. Looks like the bearing was the worst of it. has anyone taken the swash plate cradle out? I think the shaft needs to come out but it looks like that has to be done from the other side ?. Don’t want to...

Thanks for the replies! well I dig into the HST today at lunch. First hurdle was locating the plug(see pics). Looks like the armour plate was bent at some point in time... hiding the plug. I drained the transmission oil and removed the filters to find what many have described as the media...

Thanks Doc. You sure do.

HI All, I have just purchased a 900 which I knew it had some drive issues. I am new to this form and have spent the last 3 days reading over posts with similar issues. This tractor has been well used. The older gentleman I bought it off had said it started acting up in the fall. would move some...