I know its not the best but its about all I had available! Kroil and PB Blaster are not particularly ubiquitous this side of the pond but I've used 50:50 extensively on my old Land Rover - I just don't have any on hand and the current lockdown here meant I had to wait a few days for some acetone...
So I soaked the areas concerned with WD40 over the course of a few days and then proceeded to beat the proverbial out of them with a lump hammer and brass punch at an angle. After a while I won and the driveshaft came off the splines.
It looks as if the O rings on the input and output shafts...
Thank you for the info and link bordercollie.
I've removed the panel to expose the driveshaft at the front differential. Your link gave me the inspiration to have a look, but this wasn't easy as the bolt heads were very corroded....
As you can see both ends of the driveshaft have a decent...
Hello all, new member here with a new to me 2008 RTV. I've had a read around here and it looks like there's plenty of helpful people here who know what they're talking about. The UTV needs a bit of TLC - as well as performing a full service I am replacing the rear axle bearings and UJs as they...