Recent content by Wotrboi

www.BXpanded.com has a kit to test and adjust specifically for BXs.

My BX's hydraulic pressure was about 150 psi below spec. BXpanded.com has a test kit that has everything you need to check and adjust. Made a noticeable difference on mine.

If you have a Kubota BX, you might want to look at these. http://www.bxpanded.com/forks.htm No swinging sideways and no dimples in the bucket

Here's some neat stuff for that new BX www.bxpanded.com Make sure you check out the Demos videos

It's really not hard. Point the bucket down slightly and dig in a couple of inches deep. This gives a starting point. Back up, level the bucket and drop it into the crease you just dug. Move slowly forward, controlling the depth of cut primarily with the tilt (dump angle) of the bucket not...