Search results

Thanks for your input. After read a few other threads I did check that housing. It was all good.

Thanks for your input. Thats the way I am leaning. [Update on closer inspection they are all aluminum]

Now to finish the job. Discovered a cracked cylinder head. Got it tore down and just need to get online and order a head. Any advice on installation appreciated. The replacement heads I am looking at are aluminum verses the original is cast iron. Any opinions? I have located it in cast or...

Well no reply so I'll give the results. Yes you can access the water pump by way of removing the skid plate. Very simple and much faster than removing the seat components.

In previous a thread it was mentioned to remove the plastic portion of the seat to access it. It seems to me a much better way to access it would be to remove the skid plate and work from the bottom. Any opinions would be great. Got to do the job as soon as my pump comes in.

Are you looking to sell the hand throttle?

Makes my 1600 hrs on my RTV 900 seem not even broken in.

My 2005 RTV did the same thing and it was the starter solenoid contacts. Replaced the contacts and solved the problem.

Just go to HarberFreight and buy an adapter. I have one for the front and back of my RTV 900. Works great.

Put the 900 back together today. Still not completely happy with it. This was a very bad design by Kubota. When they developed the one piece drive shaft they should have offered it to the owners of the ones with the old system at a discount. I used some of the ideas I got from this forum and...

Shaft is due in tomorrow. I found out that the 25" will not replace the 24". I am going to try and reduce some of the slack by copying some or Yanmar ideas they use on their front drive shafts. I'll post some pictures when I get started.

Talked with Messick's today and my serial# called for the 24" but they said it could be either one. I was going to call Kubota but the web site says they don't provide tech service. They just refer you to a dealer.

The only down fall with that is I was planning on ordering from Messick's. I'll check the local Kubota dealer tomorrow but I bet they don't stock the shafts. Like I said earlier if the extra length is in the shaft and not the yoke I don;t think it would help any. 1400hrs It may be the first...

I checked the front drive shaft on my new to me 2005 RTV today. I found the yokes and the joints bad. The rear yoke at the transmission had been updated to the kind that clamps onto the spline. When I called about the front shaft I discovered there is a 24" and a 25" shaft. Mine has a 24" shaft...

The tires had the same 6ply rating as the ones I took off (atv type) and the same 25 inch height. As loud of a pop they made when seating I don't believe they will come unseated. The terrain I will be using it on will be level to gently sloping. No rough tail riding for this machine. It will...

I just bought the 900. It seems to be a good machine. Been servicing it and repairing little things the previous owner had failed to keep up. I am considering a coast valve to improve shifting. It's a 2005 model with 1400 hrs. Runs and operates good. Just wanted to know if anyone had had any...

I was changing the front outer cv boots today when I noticed the front tires were worn a lot more than the rears. Not wanting to replace the rears because they still had 50% tread, I had a couple of 25x8x12 on hand that had similar tread left so put them on the front. It seemed to improve the...