Search results

It is all in the x1100c workshop manual

The method i use came right out of the rtv x1100c factory service manual. The only adjustment to the servo is to center it so that the swash plate rest in neutral or in the old machines centered. If your machine creeps then the servo needs adjusted if it doesn't creep thennleave it alone. In...

John deere and caterpillar batteries are excellent long lasting batteries with great warranty. I have had similar results with napa premium batteries.

The rtv 1100 doesn't have a fan mounted on the water pump pully like the x1100c. The fan on the left side behind the cab must turn on and off in order to regulate the temp. Is your electric fan turning on and off? Also if the fan motor isn't up to snuff it can't move enough air. Have you blown...

Sticky shifting really isn't because of pressure in the hst. It is more because of gear lash friction that can be caused by the machine rolling up against the static hst or from the hst creeping into the gears tightening the lash between the gears. The rtv up until recently used straight cut...

I have had a few recall on my x1100c. There was some suspension issues at first and then the fire flap and lastly the floor mat. My dealer sent a man out for two of those and the other was done before i purchased. So recalls haven't been to bad for me. But my gripe is that it seems that these...

If you only have slight problems getting out of gear try pulling out of gear with no peddle and just as the machine has that last inch of roll

There's two issues with the pre 2024 rtv shifting. The first is the straight cut gears in the gearbox that as the machine sets on an incline the lash will be gone and there's friction between the teeth. This improves with miles. The second is mal adjusted hst speed lever causing the swash slight...

Starting the engine to raise the bed won't affect your oil level that much,just start raise shut off and check then wait a minute and check again you will see what i mean. The battery shouldn't be loosing charge just from starting. If you have alot of electronics radios amps etc then your draw...

I hope it is the alternator belt. It doesn't squeal in neutral at any rpm or peddle? Only while moving?

Very unusual for a lift pump to fail overnight. I'll gamble you are sucking air at the fuel bowl.

Old thread but it appears i need to change out the upper and lower ball joints on my x1100c. 12000 miles. 26 inch tires

Yes sir your welcome. Now just incase there are others following i will close with just one more comment for posterity. Always correct the linkage adjustments and check high idle rpm before tearing into your hst. Always begin at the peddle disconnected from the push pull cable and adjust the...

Adams repair . Search

https://www.nettractortalk.com/forums/threads/rtv900-injection-problem.15411/page-2#post-104302

please remind me? What is the max no load governed speed of the engine? What is the max governed engine rpm with the transmission in high but stalled? Would be good to know the pressure at the same rpm?

I had the dealer come out and look at my x1100c and make an offer for trade on a new one just like it. He told me probably half a dozen times i will call you in a few days with offer. That's been two weeks ago. Decisions

What your running into most likely is the push pull cable that attaches to the peddle on one end and the bellcrank at the other is just slightly out of wack. You always want the bellcrank to rest in the detent at the highest possible peddle. The way you adjust this is to loosen the clamp that...

I nominate this for a sticky

Please let us know if this works?