Search results

Arthuritis is really the expert when it comes to the hst. Did it move when you bought it?

your pictures are looking down from the top

you need to look under the passenger side. big silver thing to the right of the fuel filter

After checking the screen and refilling the tank, the next step would be to get a work shop manual and follow the procedures for checking the pressures on the precharge pump and the transmission. also make sure all the rubber hoses from the tank are still pliable and are not collapsed. This is...

also make sure you clean the screen with a solvent. I have read that sometimes they look clean but kerosene wont flow through it.

yes you will lose all the fluid. you can see the pickup strainer, just in front of the fuel tank. It has a rubber hose and hose clamp on it. Kubota uses similar strainers on their bx tractors. Make sure you dont lose the 2 rubber o rings. #30 below

The first question they always ask is did you use super UDT2 and kubota filters? Next question did you remove and clean the hydraulic oil pickup strainer from the hydraulic tank? And finally is the reservoir tank under the passenger seat full?

Doc these fit on the x1100s Bota, It is for removing air from the cooling system when refilling.

here is how I made my front bulk head so it didn't interfere with the rear window screen. I used 11ga 1 inch square tubing and 11ga flat stock. The uprights are 16.5 inches and the flat stock is 6 inches wide. once welded together I sprayed it with U-Pol Raptor Black Urethane Spray-On Truck...

Looks like there is a car manufacturer that uses the 4x110 bolt pattern. Wheels are 12, 13 and 14 inch. Center bore is 66.1 mm. Looks like they are sold in asia exclusively. https://www.wheel-size.com/size/perodua/kancil/2007/ I wonder if someone makes an adapter to change them a more common...

I replaced the hydro on my x1100 and it worked without priming. I have been following a different thread and aurthuritus went into a procedure. check out post 66 in this thread...

Is any one out there using the kubota K7812-97702 plate from the XG850 and the screen protector for the back window?

they are about $300

here are some pics

To answer your question directly, the round fill plug for the hydraulic tank and the seat support for sure. I am not sure what the long oval plug is for. I considered doing the area under the seat but I didn't want to inadvertently make the seats tilt forward or the storage tray not fit right.

I have never been a fan of Kubota's floor mats until the bx 70-1 series. My x1100 didn't come with a floor mat. I ordered one on line and was disappointed when it arrived. I used one of these on the floor...

very nice

I wonder if Kubota recognized this problem an the fix is this whole goods item U19500 BREATHER KIT

here are the instructions for the back up beeper kit as promised.

Do you have the two piece front drive shaft or the newer one piece drive shaft? I would check that before I started taking apart the knuckle cases. If the drive shaft is good I would start with the left knuckle case.