Search results

Yes the rod with the dust boot on it on the left hand side of the trans? I’m more concerned with the jerky ness on takeoff than the braking. I have the cost valve coming in the mail. If you push on the real slow the jerk isnt too bad but I’m talking so slow you have to think about it. My 04...

There is a screw and a jam nut on top of the hst servo. What does this adjust? I know the one on the bottom is the adjustment for creep

Readjusted all the linkage and it’s a little better but still jerks when you step on the go pedal. Definitely not as smooth as my older 900

Yes it did cam over with the cable attached to the pedal and the bellcrank. I’m assuming you are calling the rod that goes across the top of the trans that the hst link and throttle cable attaches to the bellcrank. I will try disconnecting the pedal cable from the bellcrank and going from there...

Mine is a 16. The rear hubs did get changed to the cast iron ones but nothing done to the a-arms

I did screw the stop all the way down and removed throttle cable but the cable was still attached to the pedal and the bell crank under the bed.

Thank you

When letting off the go pedal I can feel a clunk turns out it’s slop in the front upper a-arms. I did some searching on here and found a couple threads about it but no real fix. Has Kubota come up with a fix? My fix would be a couple shims on either side of the arm to take the slop out. Any...

Adjusted the the pedal linkage and it still jerks fwd when pushing the go pedal. The engine does idle up slightly now before it starts moving but the jerky ness is a little better. On my model the go pedal did not bind up on its own as stated in the adjustment thread instead it would just cam...

How many hours do you have on it with the plug installed Dave

Is it just the plug or do you have to buy the valve also? How long have you had it in?

Anyone have info on this https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F173432073753

I’ll have to look for those brackets. The aftermarket ones that wrap around the ROPS bar will not work with the x1100c due to there being no bar to wrap it around. The tops is all part of the cab

Why hasn't Kubota added a grab handle like the one on the pass side on the drivers side? anyone come up with a handle for the x1100c?

Not sure. Lady owned this and had dealer do all work while she owned it.

New to us 2016 x1100 is pretty jerky when pushing go pedal and hst braking is a little harsh for our taste. My old 900 I installed the coast cave and liked the feel of that. Would like the new one to act the same. No cost valve available for this model, read there is an adjustment I can make to...

Who’s using what for boot guards on x1100c? Anyone lay eyes on the kubota ones?

Elect clutch on output of gearbox

The pto gearbox is connected to the engine crankshaft via a splined shaft that is bolted onto the fan belt pulley and a small cv shaft connecting the box to the engine

Lee what wheels did you buy? What is the bolt pattern, wheel size and offset