Search results

Merry Xmas to everyone and stay save through this trying times we face!

Wonder if its a PTO safety switch issue?

Doc one of the first things I would recommend you do address dust infiltration by sealing the cab a bit better. There is a tread on here with pictures explaining what was done. Makes the cab quieter and practically dust free.

Congrats on the new machine Doc. I am sure you will be very happy with the little beast! :-)

From looking at the electrical schematic for the 1100c, the Beacon Light (center location) actually runs of a 20a relay in the fuse tray. Not sure if it is installed from the factory or is an option that has to be added to get this circuit to work. It also shows that the ground is switched to...

I based the new receiver on one I found offered by Curtis for their RTV plow system as shown below. At $300, this was way more than I was prepared to spend on it so I went to our local tractor supply store and bought a 2" x 12" receiver tube ($12) and made it fit the same location.

After a bit of thinking I decided to add a second receiver to the front of the 1100C. I attach a plow system to the machine via the OEM front hitch but found it light to handle the weight of the plow. The new receiver tube is much heavier and is welded to the OEM mount system in multiple places...

Just for our information, they are M12 x 1,25 x (length)

Doc, it would be possible but it would have to be controlled via some sort of signal activation from the motor to know when it is started. I suppose a relay circuit connected to the Alternator output may be an option. It may be a little more difficult in the 1100C as the hour meter is integrated...

12v with up to 1 hour timer delay: This should work if wired properly. https://www.ebay.ca/itm/2x-DC-12V-Home-Automation-Time-Delay-Electronic-Module-Circuit-Timer-Boards/173945593460?hash=item287ff71e74:g:8LoAAOSw2sFdE6v1

One of the things I did was to add a piece of 2" x 3/16 angle iron below my front receiver to beef up the receiver sleeve. I found that the metal used was on the light this side and as I use this to mount the snow plow it was rounding out the edges. It worked great and really strengthened up the...

This will only be possible via some sort of electrical timer circuit connected via fused link to the battery. You may be able to find a variable timer circuit on Ebay for this purpose.

Check your PM.

Actually it is a 2017 and now has 2500kms on it and 180hrs. It is amazing how sealing of the inside has done to keeping the interior of the cab clean. The lower noise level is a bonus!

Hope this helps!

I did the following to help keep dust out of the cab but surprisingly is lowered the internal cab noise quite a bit. I sealed up both door vents by the side of each seat. I used duct tape and sealed the tray that exposes the engine under the seats. I used black silicone rubber and sealed all...

Anyone know the bolt size for the 4 bolt holes in the front bumper by the 2" receiver on the 1100C? I tried chasing them with a 7/16 fine thread tap but it seemed sloppy and the 1/2" Fine thread wont start.

Hey guys, anyone here use the Meyer Home plow on their RTV for snow clearing? This particular plow is mounted using the front 2" receiver. What I was wondering is the front receiver on the 1100C heavy enough for this purpose. Thanks

Hey Craig, I live on Pioneer Line. Let me know when you going to be over in the Beaver Pond rd area I will pop over to see you.

hahahahah, where you located Craig?