Search results

Craig, I live in Deer Park on Salmonier Line.

Craig, I am also in NFLD. Congrats on the find. These are little tanks when working. I am sure you will enjoy the capabilities of this machine when the kinks get worked out. Regards, Jim

I was thinking more on the lines of a POT controlled delay function mounted in one of the extra switch knockouts. I will research this and update when I find something.

Has anyone figured out or know of a aftermarket setup for a Intermittent wiper setup for the X1100C?

I have had a few synthetic ropes on my UTVs over the years. I have found them not quite as durable as cable but far easier to handle. You have to be very careful with them and ensure you use a Hawse Fairlead and be careful of fraying.

Smoke Screw??

Thanks Aurthuritis, the belt it driving me crazy on first startup.

Are there two separate fan belts on the 1100C, one for the alternator-Fan and a separate one for the air conditioning compressor? Also, are there any tips as to adjusting this? Thanks.

Easy enough to do especially where the filter is located on the 1100C.

I Thought I would give a review of the X1100C I purchased three months ago. It had 40hrs and 400kms on it when I bought it home. So far the machine has performed flawlessly. Runs strong and is quite comfortable for what it is. Below are some of the pros and cons I have observed: Pros: a) Fairly...

I assume you know it is cleanable? I clean mine by blowing it out with compressed air.

Be proud and strong folks. There is an evil in the world that wants to destroy our way of life. Resist!

Good to know. Strange to see both these though.

My RTV X1100C has two separate oil caps. Whats up with this?

When I bought my 2017 X1100C it came with a Meyer plow system. The plow has its own lift hydraulics pump to lift and lower the blade but has to be manually angled. I was considering re-purposing the bed dump circuit to support an angle cylinder on the plow for the winter months. Would this be...

I was thinking the same thing. Did you bring the wires in through the top of the rubber blocks or lay them under the blocks and seal them with the silicone?

I am going to install two LED lights to the front of the cab on my 1100C. I am aware that the harness is pre wired to accept these but is there any advice as to how to seal the wires that go through the mounting plate? Never mind, used the search feature and found plenty of info on this...

Understood. I will inquire to the dealer about the hub upgrade also. Thanks

I assumed it was normal for this sort of setup. Nice to verify it is just part of owning this sort of machine. Thanks guys!

Recently purchased a 2017 X1100C with 44 hours on it. Machine is in new condition and I just completed its 50hr maintenance routine. I must say it has a great ride and very comfortable with the cab, air, and heat. The only issue I have found is that when I ride over rough ground, I get a...