Search results

Sorry i don't remember exactly and i don't have a wsm for your model. Check ebay for a used wsm? It will have the instructions and reading you need anyway.

Success. Glad you figured it out

Get a set of test gages of of amazon or someplace and check the charge pressure. Did you examine the off brand filters afte you removed them to see if they came apart inside? What was the transmission oil change schedule? Is it possible that the 300 hour oil was 18 years old? If that is the...

Yep he said he changed a weak battery with a new battery and this is when the no start happens. It is possible to get a bad battery new from store? Check simple things first

I would wager you have a bad battery. You should load test the battery. You might try putting your volt meter from positive bat terminal to a frame ground and then turn the key to start and see of the 12 volts goes away instantly. Check the ground cable to frame connections.

You must have a charge relief valve. The brass plate is severely worn and would probably be a real deterrent to pressure. The plate with deep marks needs replaced. The rotating valves look ok. The swash and it's tilt bearings look ok.

Much easier to pull the glow plugs

There is a company in the usa that manufactures a more reliable set of contacts for your kubota denso abd dodge starters. All you have to do is replace the worn contactors in the solenoid. It's easy cheap and better than oem. Anyone can do this with just normal hand tools

That's funny cause mine will pull a hill with 300 lbs of feed in the back and never less than 14 mph. But my hill and yours might be a little different 🤔

Common issue. With that many hours and no service history the best is start with the simple things first and work your way through it. First thing is check the full throttle rpm with a tach do that and report your finding

I used fluid film snorkel when mine was new.

Would you expand? Was the key missing

Ok. So you have put a tach on it and confirmed? This has been a problem for years for just a few. The idle set to low at factory. The symptoms are exactly as yours. Could be a bad or improperly installed harmonic ballancer

What rpm is it ideling at?

Simple things first. What is your idle rpm?

Before you get to far into the hst you should first confirm a few important things. Check your max rpm at no load and with the machine stalled hot oil. Should be 3800 no load 3600 stall. Also check your valve lash and confirm that your engine is firing on all cylinders. And take out the...

Your pressure sounds good. Have you tried pulling the hand throttle all the way revving the engine full and then feather the peddle and see what happens? Report back

What year? Simple things first. Change oil in the transmission and hydraulic tank with sudt. Change both filters with oem kubota filters. Find the link to the operator manual and read it. Stoopid question??? Is it in gear? Does it grind when trying to slip it in gear at half throttle? Check...

There are a huge amount of parts commonality as long as you stay in your model. Ktc made the exact same machine for many years. Check ebay for complete transmission and sub assembly etc. Use kubota for rebuild parts within the assembly. The parts you refer to is the valve block and swash...

It just pops out! Easier said than done though.