Search results

Is any one out there using the kubota K7812-97702 plate from the XG850 and the screen protector for the back window?

they are about $300

here are some pics

To answer your question directly, the round fill plug for the hydraulic tank and the seat support for sure. I am not sure what the long oval plug is for. I considered doing the area under the seat but I didn't want to inadvertently make the seats tilt forward or the storage tray not fit right.

I have never been a fan of Kubota's floor mats until the bx 70-1 series. My x1100 didn't come with a floor mat. I ordered one on line and was disappointed when it arrived. I used one of these on the floor...

very nice

I wonder if Kubota recognized this problem an the fix is this whole goods item U19500 BREATHER KIT

here are the instructions for the back up beeper kit as promised.

Do you have the two piece front drive shaft or the newer one piece drive shaft? I would check that before I started taking apart the knuckle cases. If the drive shaft is good I would start with the left knuckle case.

It helps to remove the exhaust cover, inner mud flap and the wheel to access the reverse switch. If your back up beeper is already installed you can hook up the lights without removing anything. If you look from the back the backup beeper is at the intersection of upper crossmember and the...

is that an 1100 or x1100? I read somewhere the x1100 is limited slip so it will act differently than the rear axle.

I miss spoke earlier, if a guy just wanted back up lights the parts are pretty reasonable. here are the parts needed and cost at messicks. If there is interest I will post the instructions from the kit. Item Description quantity Price K7591-96410 STAY,SWITCH BACK 1 $7.20 03714-50520...

the RTV doesn't come with the reverse switch, which is part of the beeper kit. So now I have reverse lights and beeper. I originally wasn't going to attach the beeper, but since I had it I thought I might as well.

is Toolman77 still around? I am interested in his gun mounts.

here is a very simplified wiring diagram of how I connected my back up lights. I added 3 water proof electrical connections and ran the drivers side wires in the machine's wiring loom and 2 water proof connectors at each light. I maintained the plugs that came with the back up beeper, and the...

So I finally installed back up lights for my x1100. I made an L bracket and they sit above my brake lights. I tied into the back up beeper instead of installing a relay and running extra wires. The lights draw 48 watts or 4 amps and the circuit seems to handle the load. here are some...

Thanks for your post. I just verified that the front section of the bed is the same part number for the x900, x1100 and the 850. So all I need to do is drill a couple of holes in the side rails. I like your set up.

I recently saw a video for the RTV 850 and wondered if the box plate for the 850 would fit on the 1100. Attached is a print out of the box plate assembly for the 850

Did see the Kubota uses SuperWinch winches with Kubota stickers and colors. They are pricy.

I haven't purchased one yet but was thinking seriously about this one https://www.amazon.com/gp/product/B07DP8DQQH/ref=ox_sc_saved_title_3?smid=A2UUWCCR4G5EFA&psc=1 I read some where that you need one that can pull twice the weight of your UTV.