Search results

I live in eastern Kentucky and have been riding my RTV900 for about two years without incident. I am having some dozer work done on my property and was following behind the dozer operator when I went unlevel and tipped over. I had my seat belt on and did not receive any injury. My foot did get...

I'm trying to remove the accesory/lighter plug to move it to a different location. I can't figure out how to remove it without breaking it. Any suggestions?</p> </p> kas1263</p>

</p> Warn has a recall on their contactors. http://www.warn.com/atv/recall_notice.shtml </p> </p> </p> kas1263</p>

Warn has a recall on their contactors.</p> </p> http://www.warn.com/atv/recall_notice.shtml</p> </p> </p> kas1263</p>

I went to Amazon.com looking for a better price for the unit and found some reviews. Go here to see them.</p> http://www.amazon.com/review/product/B0013TM0Z0/ref=sr_1_1_cm_cr_acr_img?_encoding=UTF8&showViewpoints=1</p>

Re: RTV Starter ? About 10 years ago I bought a used Kabota tractor from a local Kubota dealer. There was a warning dash light out that I wanted repaired before I took possession of it. The dealer said yes and delivered it a week later. About a year later I needed to open the dash and to my...

</p> I have had both of my latches replaced. One was cracked, the other was too loose. My dealer replaced both, no charge (under warrantry.)</p> </p> kas1263</p> </p>

Got it fixed. Today I took the side panel off, cleaned out the dirt, sprayed a little bit of WD 40, tried it out, and it worked.. Thanks to all!!!</p> kas1263</p>

My warning light telling me my parking/emergency brake light is out on my RTV 900. It's not the bulb but I beleive there is a wire loose somewhere. It use to flicker or come on momentarly but has stopped. How do I find and check the proper wires to get it working again?</p> </p> KAS1263</p>

</p> I bought a Gorilla winch last year and had to drill holes to install it. The winch I got did not match the mounting plate that came with my RTV900.</p> </p> I did strip a bolt on the mounting bracket and Gorilla replaced it with out charge and no hassle.</p> </p> </p>

</p> Hey Two Guns </p> Where did you get your sliding window from. I like it!!!</p> </p> kas1263</p>

Thanks BZ. My switch is a three way but is retangular. It has a brace with it that can screw somewhere on the dash. I was think of putting it in the hole for the turn signals but am worried about not doing it right and screwing up the dash. I like your idea of just wrapping the cord and putting...

I am installing a 2500 Ramsey winch to my RTV 900. Everything has gone smoothly until I got to the switch installation part. I can't understand the instructions.</p> Where does the remote and stationary switch go? Pictures would be most helpful.</p> </p> kas1263[:S]</p>

Tommy-</p> I have a RTV 900 with aftermarket doors and rear window (Curtis). You would need to compensate about an inch so the square pipe wouldn't get in the way of the housing required on the rear of the cab.</p> </p> </p> kas1263@66 hours</p>

Where would you attach the safety chains for a trailer on a RTV 900?</p>

Re: RTV 1100 spark arrestor If that is the spark arrestor what is the gray plastic/rubber thing on the end of the tail pipe? </p>

Could you make a set for a RTV900? How much would it cost? And how would you send it?</p> </p> kas1263@56 hours</p>

Just got my 50 hour check up at 55 hours. All fluids and filters were changed, along with a new gas cap and two new window clamps. Price $98.00 for parts and free labor. The THING runs like a differnt machine. So much smoother. To all RTVers in eastern Kentucky and western West Virginia -I...

I have installed the soft doors from Kubota. They are pretty easy to do and take about an hour with all the hardware. kas1263

I like your floor in the cab. How did you do that? Kas1263