Search results

  1. K

    my place in da nort woods

    some pix near Bruce wi middle is sunrise.. my snow shovel is last..
  2. K

    farmall m IDing parts/model

    I am in the process of ltrying to fix a plug fouling problem mostly cyl 2,3,4... It turns out it is non standard.. Pistons are 4 inch M&W. but flat topped..!! It should e a gas only tractor (1950) I need to get new rings and gaskets. That is not a big concern right now.. but I would...
  3. K

    norden or wide front axels

    I have a norden axel on IH 560. the steering arm cracked. I am getting it re welded but I can not find a parts diagram of norden axel. I did find Schwartz axel diagram and it appears their steering arm looks the same. Schwartz p/n is A3049 fits 560 and others. It seems the only...
  4. K

    farmall 560 pto.

    While baleing my 560 diesel started to make grinding gear noise when clutching in the pto. holding foot clutch untill the tranny stopped spinning gears had no effect. did not always do it. but at least 75% of the time. It would eventually engage and run the baler. My IT manual...
  5. K

    ford 8n bolt

    I'm trying to get an 8N started. I suspect timeing as there is spark but it won't even bark on ether... the bolt / crank arbor(????) is missing. I tried a 9/16 th fine thread butit just wobbles in and out. next size bolt is 5/8th and seems too big. It is difficult to get my big...
  6. K

    ih 560 du al loader

    Any one have a clear picture of the axel mounting of a du al 340 to a 560 or super MTA (same axel) I need a verticle look at it as the loader posts and arms are wider than the square culivator/drawbar/fender mounting pads onthe axel.. Don K9yli@aol.com Northwestern wi..
Top