2008 RTV1100 -fuel gauge, speedometer & temperature gage

[Ghulihan]

Hello All

None of the analog meters work. The digital hour meter doesn’t work. The glow plug symbol illuminates as normal. Also the wiper/windshield washer doesn’t work the fuse is good and checks good with ohm meter.

Pulled the display out of the dash all cables were seated and secure . Have not been able to find an electrical diagram that shows the meters .

Any help is highly appreciated !

 

[bordercollie]

Hi and welcome to the forum ! Messicks should have diagrams of the wiring in their specific model diagram pages. I agree that they are not the best since in b and w. My workshop manual went with my RTV when I sold it but I used the Messicks site often because I could enlarge it on the computer and then print off.
Can you remove one of the wire plugs going to the meters and check with a light meter? I would check all of the fuses in case there is a bad one in the mix. a mouse could have been at work on the main wire carrying power there maybe? https://www.messicks.com/vendor/kubota

 

[bczoom]

Just tossing this out there once you find you're wiring issue.

None of the analog meters work.

Once you get the digital gauges and washers/wipers working, be advised that Kubota had a lot of problems with their early analog gauges, particularly the fuel gauge. I've gone through many sets and finally gave up.