Rtvx1100c front halogens wattage

[Walnut1]

I ordered a Nilight light bar for the front of my new rtv, do I need to use the power supply cable, or will the existing kubota wiring that supports the factory lights be sufficient? I can’t find the wattage of the front light option anywhere.

 

[Walnut1]

The Nilight light bar is 234 watts.

 

[shinnery]

At 19.5 amps I would use at least 10 gauge wire (maybe 8 ga.) and would consider a relay to keep that current out of my switch.

 

[aurthuritis]

that is a lot of amps. is this a halogen light bar? i thought the LED systems were low amperage? am i wrong???

 

[shinnery]

Original post says HALOGEN nothing about LEDs.

 

[aurthuritis]

Original post says HALOGEN nothing about LEDs.

oops! i missed that part. Thanks

 

[Walnut1]

No, it’s a led light bar. The kubota work lights I want to replace are halogen I believe.

 

[Walnut1]

I think I read the kubota are70 watts total, I’ll check the light bar again.

 

[aurthuritis]

just check the watts on your new lightbar and see if it is less than oem. if it is less or near oem it should be fine to use the existing wires. pretty sure the cab is pre wired so all you need is a switch

 

[Walnut1]

I ordered the harness that is made for the light, it has a switch and relay. I’m just not to comfortable running it under my headliner.

 

[aurthuritis]

i thought the harness was already under the headliner and all you need is the lights,switch and relay?

 

[aurthuritis]

i thought the harness was already under the headliner and all you need is the lights,switch and relay?

oh ok! i see what you are talking about. "sorry"