Skid Steer Adapter for my ML106

[PBinWA]

Special thanks to rback33 for the tip!

Yesterday I picked up my Skid Steer Adapter from my dealer . Officially, Mahindra doesn't offer a Skid Steer adapter for the ML106 loader but they do offer it for the ML110. Yes, it appears they are inter-changeable.

So I now have the adapter, some adapter blanks, some steel, a flush cutting tip for my torch, and a set of Bradco Pallet Forks too. All I need now is some dry weather and free time and I can change my bucket over to a skid steer bucket.

I'm waiting for snow season to pass but will add some pic's to this thread once I get cutting and welding.

Thanks again rback33! If you're ever out west let me know and I'll buy you some beer!

 

[Dougster]

Special thanks to rback33 for the tip!

Yesterday I picked up my Skid Steer Adapter from my dealer . Officially, Mahindra doesn't offer a Skid Steer adapter for the ML106 loader but they do offer it for the ML110. Yes, it appears they are inter-changeable.

So I now have the adapter, some adapter blanks, some steel, a flush cutting tip for my torch, and a set of Bradco Pallet Forks too. All I need now is some dry weather and free time and I can change my bucket over to a skid steer bucket.

I'm waiting for snow season to pass but will add some pic's to this thread once I get cutting and welding.

Thanks again rback33! If you're ever out west let me know and I'll buy you some beer!

A very good move PB!!! I doubt you will regret spending the money.

Just make sure the latching mechanism is well-lubed and functions properly... and that fit with your attachments is good. All of my previous problems were due to worn and/or defective parts.

Dougster

 

[rback33]

Special thanks to rback33 for the tip!

Yesterday I picked up my Skid Steer Adapter from my dealer . Officially, Mahindra doesn't offer a Skid Steer adapter for the ML106 loader but they do offer it for the ML110. Yes, it appears they are inter-changeable.

So I now have the adapter, some adapter blanks, some steel, a flush cutting tip for my torch, and a set of Bradco Pallet Forks too. All I need now is some dry weather and free time and I can change my bucket over to a skid steer bucket.

I'm waiting for snow season to pass but will add some pic's to this thread once I get cutting and welding.

Thanks again rback33! If you're ever out west let me know and I'll buy you some beer!

As most know I WILL be out west next week at Tulare. I will get to meet Dave for the first time face to face.

 

[Dougster]

As most know I WILL be out west next week at Tulare. I will get to meet Dave for the first time face to face.

Damn cushy job you've got there Kid! Lots of perks too!

At least take a bunch of picture out there for your older, less fortunate friends.

Dougster

 

[PBinWA]

As most know I WILL be out west next week at Tulare. I will get to meet Dave for the first time face to face.

OK, when you're in the Pacific Northwest (more specifically the Portland Oregon area)!

I'd say something bad about California but this is the wrong forum!