Bindian
Member
I finished my light installation on my canopy today. Since I work nights and sleep late in the day on my time off, I decided to install lights on my canopy so I can dig late into the evening. I bought two round lights from TSC. I installed them in the angle of my canopy by drilling one mounting hole. I had a hole at the top of the ROPS, so I added one down near the fender where the ROPS flares out. I ran two wires in heat shrink and pulled them through the ROPS with wire to make a wiring harness. I removed the factory plow light from the fender brace and wired the canopy lights into the plow light's wiring. Then I drilled 3 holes in the canopy frame and installed wiring clamps to secure the wiring harness. I tried the lights out this evening. They work great, but I will take a wrench out with me tomorrow and adjust the windage on them as I had the light mounting nut too tight for hand adjustment. But the pivot works great as I can adjust them to shine at full BH reach or down to shine on my feet.
hugs, Brandi
hugs, Brandi