I just ordered the wiring harness from SuperBrightLights for the lightbar. Just easier than trying to figure out the factory wiring, I received NO wiring diagram and can find none online. I talked to dealer I purchased from and he emailed me install directions for RTVX1100 however the directions are for some other application and do not include my model.
Frustrated :-(
It’s as simple as can be. Order the switch from kubota for the front work lights. Unscrew the panel where the windshield wiper switch is and pull it down. Inside there will be two square/rectangle plugs taped to a bundle of wires. I think it’s the blue plug for the front work lights but it’s can be trial and error. It’s a 50/50 shot of getting it on the first shot.
Next, pull off the cover on the front of the roof and expose the wires. Pull enough out that you can cut off the factory plug. Mount your light bar as you see fit and match up the positive to positive and negative to negative.
Resecure the cover and you’re in business. The separate wiring harness would be way way more complicated and not nearly as clean. This is about as easy as a project you can do from the wiring stand point. Like one wrench out of 10
Brett
It’s as simple as can be. Order the switch from kubota for the front work lights. Unscrew the panel where the windshield wiper switch is and pull it down. Inside there will be two square/rectangle plugs taped to a bundle of wires. I think it’s the blue plug for the front work lights but it’s can be trial and error. It’s a 50/50 shot of getting it on the first shot.
Next, pull off the cover on the front of the roof and expose the wires. Pull enough out that you can cut off the factory plug. Mount your light bar as you see fit and match up the positive to positive and negative to negative.
Resecure the cover and you’re in business. The separate wiring harness would be way way more complicated and not nearly as clean. This is about as easy as a project you can do from the wiring stand point. Like one wrench out of 10
Brett
Thanks for the info....there is no power to either plug on mine..just 2 wires run from switch panel to roof. just not that easy. The factory harness does come with 40 amp and was very easy to connect.
You didn’t have two 5pin disconnects in your overhead panel?