jwrivendell
New member
Hi ... I'm in a pickle here. I own an E350 - DI and just bought a tiller. The drive shaft is too long. I know that I need to shorten it. My problem is that the drive shaft I have is 27 1/2 inches and the length I need is about 19 inches. I need to cut close to 9 inches off this thing. That makes for pretty darn short drive shaft. Can this be done? I mean it really is going to leave a small section of the plastic cover and a couple of inches longer of the actual shaft itself.
Can I get a bracket that will mount where the lift pins are on the tiller and push the mounting point further out thus allowing me to have a longer drive line? Can I get longer lift arms? Or do I just cut the thing that short?
Any advice would be appreciated.
- JW
Can I get a bracket that will mount where the lift pins are on the tiller and push the mounting point further out thus allowing me to have a longer drive line? Can I get longer lift arms? Or do I just cut the thing that short?
Any advice would be appreciated.
- JW