Recent content by Bindian

Ttoy, My new pneumatic framing gun trumps your big hammer.:hammer: hugs, Brandi:blob_blue:

I just purchased two 7520s today. That is right. Two new 7520s. Supposely they have zero hours. They are shipping sight unseen to me now. You can check check out a photo of them by following this link. Toy Mahindra models? - &&&&&&&&&&&&.com hugs, Brandi

The water level keeps going down. I was hoping the thunder storm that dumped 2 inches in an hour on Lake Livingston (just northeast of us) would make it to us. It didn't. We only got 1/4 inch of rain this morning. I got a shot of Booger down in the pond chasing frogs. Next to chasing...

I'm not sure if this is the right spot for this. Please contact your Congress Critters on this important issue. Please spread the word. hug, Brandi http://www.txfb.org/TxAgTalks/post/2011/07/25/New-regulations-could-threaten-farm-transportation.aspx...

Tomcat1083, Welcome to NTT.:tiphat: I am not sure when not running, but with the engine running and it can be do that, it means you have a leak and low level of fluid going to the pump. I had that before. :tiphat: Your pump may be going out.:gotsmoney: The 3PH should go down with weight...

Erik,:wave: Oops:pat:..........................time for a new tractor.:clap: Honestly, besides adjusting the clutch linkage I haven't a clue.:idea::confused2: hugs, Brandi:blob_blue:

Sundug, Glad to hear you got it sorted out.:a1: hugs, Brandi

Doug,:wave: My 6520 has an arm to hold the remote open for my backhoe. I have never tripped my relief valve on the tractor. Could be a bad relief valve tripping early. hugs, Brandi

I get it now. Thanks for the additional explanation. I think a small lathe would be a welcome project maker in any shop. hugs, Brandi

Istillcare, What position is your draft control in? Try raising it up to full up and then try to raise the 3PH. hugs, Brandi

Gary66,:clap: Thanks so much.:thankyou2: I will try to help when I can.:lucky: If you sent your posts to me and I posted them.............then they would be my projects.:whistling: Maybe if you filled out your user profile, that might help.:thumb: I just read all your posts...

Gary66,:smile: :wow: I finally know what kind of tractor my childhood friend's Dad used in his garden! Now I know it was a Perrin Garden Tractor. :thankyou2: Is that rear axle geared or chain reduction? :confused2: My Dad had a David Bradley walk behind tractor when I was young...

I still care,:tiphat: I had a mid 1970s Ford 3055.:thumb: The knob you are referring to on my Ford didn't do a thing, so I just figured it was inop.:o As I remember, the draft control lever should be in the up position if you want to raise the 3PH with the position lever. You...

Gary66, Interesting design.:a1: I don't understand this cylinder's function. :confused2: Can you explain a little more its intended use? hugs, Brandi:blob_blue:

Gary66,:tiphat: I look forward to reading about your projects.:thewave: How big is Redding, Ca.?:confused2: hugs, Brandi:blob_blue: