Does anyone happen to have the factory height of them? I think mine are worn out but wanted to check the height before spending the money on a new set.
The splines are worn completely out on both ends of mine and it flops around real bad, needless to say. Does anyone have any leads on where I can get a pair? Kubota doesn't list them separately, they only sell the complete drive shaft assembly for $883.68. Thanks
Thanks. I just got it out. Now I need to know if anyone has any leads on where I can get new ends for it. The splines are wore completely out on each end pieces and the whole shaft flops around badly. Kubota doesn't list them separately on their parts diagram, only the complete shaft for $883.68.
Ok I'm back. I finally got the HST pump in. Just to recap what I've replaced, HST pump, HST pump valve plate, charge pump and the charge pump relieve spring.
Still have the exact same problem. Idles at about 50#, revs to about 80# and stays there as long as the throttle is held open rev it...
I'll order a new HST pump. Like I said, I already replaced the valve plate for it with a new one so at least that's taken care of. Eventually something has to work.
When I first got it, there was some damage to the top of some of the pistons and in some of the cylinders in the HST pump. I cleaned the damage up in both and they were compressing with no drag. Do you think that might be where the problem is?
I also had to replace the valve plate for the HST...
I just discovered something new, at least to me. I've been moving the lever that controls both the regulator valve and engine in order to rev it up. I just started it and it is still idling at 55# pressure. I revved the engine directly at the throttle control on the engine, not activating the...
I didn't state what is happening with the pressure correctly. When idling, it's at 55#. When I rev it up it jumps to about 80-85# and immediately falls to about 20# and stays there as long as the engine is revved up. When I let it go back to idol, it goes back to 55# pressure.
Sorry for the...
Ok, I finally received my pressure gauge kit, Amazon failed miserably on this. When I start it up and let it idol, it stays at 55#. When I rev up the engine, it will go to 80-85# and then immediately fall to about 20# and stay there. Any ideas?